ALOHA Cabled Observatory

 

Home

ACO Update

Experimenters Guide

Observatory Engineering Documents

Project Timetable

Publications & Reports

Contact

Links

Site Map

About ESF

 

Aloha Project Documentation

Rabbit Remote Programmer

 

Remote Programmer of Rabbit 3000 Microcontrollers:

          Each of the six Rabbit 3000 microcontrollers operates from software programmed from flash memory at power on.  However, with this module there is the capability to remotely program any of the six controllers over the TCP/IP after deployment.  The new programming software can be either temporary (dynamic memory) or permanent (flash memory).  On reset the flash memory program is always started.

 

 

Remote Programmer Circuit Board

Remote Programmer Schematic
   
   
   
   

 

Back To Aloha Observatory Block Diagram    Observatory Schematic Diagrams List Page

 

Rev: 08/10/2007

 

 

 

This site maintained by Bill Doi
Copyright © 2004  [SOEST/ESF]. All rights reserved.

The ALOHA Cabled Observatory is funded by the National Science Foundation

Revised: October 24, 2007